Two Stage Air Compressor Parts for sale

TOOLS:

•	Air Compressors
•	Bobcats, Used
•	Bulldozers
•	Chain Saws
•	Excavators
•	Generators
•	Log Splitters
•	Pressure Washers
•	Snowblowers Plows Etc.
•	Tractors
•	Bins
•	Dollies
•	Ladders
•	Golf Carts

Two Stage Air Compressor Parts For Sale

Purchase quality Two Stage Air Compressor Parts at discount prices! Secure online payment.

NorthStar Air Compressor Pump Pumps come with cast iron sleeve and enough CFM to power most tools used on construction sites. Efficient compact design.	Coleman Powermate 5 Peak HP, 20 Gallon Air Compressor 5 peak HP dual voltage motor and long lasting twin cylinder pump. Four cast iron sleeves and aluminum cooling fins to reduce heat.	Pressure Switch for Dual Stage Air Compressor DUAL STAGE switch has a 100-200 PSI range. For 1/2 to 3HP compressors when used with a magnetic starter. 1/4in. male pipe fitting.
Ingersoll Rand Tow-Behind Compressor Ingersoll Rand 3 cylinder diesel engine runs 1.4 GPH at 75% load. Pressure range is 80-125 PSIG and free air delivery is 90 CFM.	Coleman Powermate 5.5 Peak HP, 15 Gallon Capacity Air Compressor Easy to maintain, oil free air compressor comes fully assembled.	Ingersoll Rand 12 HP TS Series Gas-Powered Air Compressor Has 30 Gallon Horizontal Tank Two-stage splash lubricated pump features new Enbloc design for increased performance.

Air Compressor Tanks
Self Inspection Checklist:
Do all new and existing air compressor tanks installed
after 1971 meet applicable design codes?
[29 CFR 1910.169(a)(2)]

Note: Equipment purchased from reputable dealers can be
assumed to meet applicable codes if the equipment was
designed as an air receiver; otherwise, the product literature
will have to be consulted. The tank should have an American
Society of Mechanical Engineers (ASME) label.

Are air compressor tanks installed such that all drains,
handholes, and manholes are easily accessible?
[29 CFR 1910.169(b)(1)]

Are air compressor tanks installed above ground and
in an accessible location?
[29 CFR 1910.169(b)(1)]

Is a drain pipe and valve installed at the lowest point of
every air compressor tank so accumulated oil and
water can be removed?
[29 CFR 1910.169(b)(2)]

Is the air compressor tank drained frequently (either
manually or by an automatic drain valve) to prevent
the accumulation of excessive amounts of liquid
in the tank? [29 CFR 1910.169(b)(2)]

Is every air compressor tank equipped with a readily
visible pressure gauge and with one or more
spring-loaded safety valves?
[29 CFR 1910.169(b)(3)]

Note: The total relieving capacity of this safety valve
shall be enough to prevent pressure in the receiver from
exceeding the maximum allowable working pressure of
the receiver by more than 10 percent.

Is the design such that no valve is located between the
air compressor tank and the safety valve(s)?
[29 CFR 1910.169(b)(3)(ii)]

Are safety valves located and installed so that they cannot
easily be made inoperative by any means, including the
elements? [29 CFR 1910.169(b)(3)(iii)]

Are safety valves tested frequently and at regular intervals
to determine whether they are in good condition?
[29 CFR 1910.169(b)(3)(iv)

| | | | | | | | | | | | | | | | | | | | | |